Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Aurora R7 Service Manual

PDF

Procedure

  1. Locate the CMOS jumper (P217) on the system board. For information on the location of the CMOS jumper, see " System-board components".
  2. Disconnect the system-board power cable from the system board.
  3. Remove the jumper plug from pins 217 and replace it on pins 216 (P216).
  4. Wait for 5 seconds.
  5. Remove the jumper plug from pins 216 and replace it on pins 217.
  6. Connect the system-board power cable to the system board.
    Figure 1. Clearing CMOS settingsImage: Clearing CMOS settings
    1. jumper plug
    2. P217
    3. P216
    4. system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\