If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:If either the processor or the fan and heat-sink assembly is replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
The following image(s) indicate the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure.
Steps
Gently place the fan and heat-sink assembly on the processor.
Align the screw holes on the fan and heat-sink assembly with the screw holes on the system board.
In sequential order (1>2>3>4) tighten the four captive screws that secure the fan and heat-sink assembly to the system board.