NOTE:When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.
NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.
NOTE:Screw color may vary with the configuration ordered.
Table 1. Screw listScrew list
Component
Secured to
Screw type
Quantity
Screw image
Left-side cover
Chassis
6-32, hex head
2
Solid-state drive
System board
M2x3.5
1
Wireless card
System board
M2x3.5
1
Antenna modules
Chassis
M3
2
3.5-inch hard drive
Chassis
6-32, pan head
4
VGA-connector board
Chassis
6-32, thumb
1
Power-supply unit
Chassis
6-32, hex head
3
Optical drive
Chassis
M2x2
2
Media-card reader
Chassis
6-32, pan head
1
I/O-cover door
Chassis
6-32, pan head
1
Fan and heat-sink assembly
System board
M3 (captive)
4
System board
Chassis
6-32, hex head
8
System board
Chassis
6-32, M.2 card mounting screw
1
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\