- Notes, cautions, and warnings
- Working on your computer
- Removing and
installing components
- Recommended tools
- Removing the cover
- Installing the cover
- Removing the hard drive assembly
- Removing the hard drive from the hard drive bracket
- Installing the hard drive into the hard drive bracket
- Installing the hard drive assembly
- Removing the VGA board
- Installing the VGA board
- Removing the system fan
- Installing the system fan
- Removing the memory module
- Installing the memory module
- Removing the heat sink
- Installing the heat sink
- Removing the processor
- Installing the processor
- Removing the speaker
- Installing the speaker
- Removing the coin cell battery
- Installing the coin cell battery
- Removing the system board
- Installing the system board
- System board layout
- List of compatible monitor models
- Troubleshooting your computer
- System Setup
- Specifications
- Contacting Dell
OptiPlex 3046M Owner's Manual
Installing the VGA board
- Align and insert the VGA connector into the slot on the computer.
- Tighten the screws to secure the VGA board to the computer.
- Connect the VGA board cable to the connector on the VGA board.
- Install the cover.
- Follow the procedure in After Working Inside Your Computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\