Dell OptiPlex 5070 Small Form Factor Service Manual

Installing the hard drive and optical drive module

1. Insert the tabs on the hard drive and optical drive module into the slot on the system at 30 degree angle [1].
2. Connect the optical drive data cable and power cable to the connectors on the optical drive [2, 3].
   
3. Lower the hard drive and optical drive module so that it is placed in its slot [1].
4. Slide the release tab to lock the module [2].
   
5. Route the hard drive data and power cables through the HDD-ODD release tab [1].
6. Route the optical drive data cable and power cable through the retention clips [2].
   
7. Install the:
   1. HDD assembly
   2. Front bezel
   3. Side cover
8. Follow the procedure in After working inside your computer.