OptiPlex 7070 Tower Service Manual

Installing optional VGA module

1. To remove the metal bracket as shown below, insert a flathead screwdriver in the hole of the bracket [1], push the bracket to release the bracket [2], and then lift the bracket out from the system.
   
2. Insert the VGA module into its slot from the inside of your computer [1] and connect the VGA cable to the connector on the system board [2].
   
3. Replace the two (M3X3) screws to secure the optional VGA module to the system.
   
4. Install the system fan .
5. Close the front panel door.
6. Install the:
   1. Front bezel
   2. Side cover
7. Follow the procedure in After working inside your computer.