Dell Command Line Reference Guide for the S6010–ON System 9.14.2.4

To delete the configuration, use the no ntp source command.

interface

Enter the following keywords and slot/port or number information:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For the Management interface, enter the keyword ManagementEthernet then slot/port information.
• For a port-channel interface, enter the keywords port-channel then the port-channel ID.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.14.1.0

The support for configuring management interface is introduced in S4810 and S4820T.

9.13.0.0

Added support for configuring Management interface.

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S3148.

9.10(0.0)

Introduced on the S6100–ON.

9.8(2.0)

Introduced on the S3100 series.

9.8(1.0)

Introduced on the Z9100–ON.

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.7(0.0)

Introduced on the S6000-ON.

9.2(1.0)

Introduced on the Z9500.

9.0.2.0

Introduced on the S6000.

8.3.11.1

Introduced on the Z9000.

8.5.1.0

Added support for 4-port 40G line cards.

7.6.1.0

Introduced on the S-Series.

7.5.1.0

Introduced on the C-Series.

6.1.1.0

Introduced on the E-Series.