Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge T330 Owner's Manual

PDF

Installing caster wheels

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Phillips #2 screwdriver ready.
  3. Place the system on its side on a flat and stable surface with the base of the system extending off the edge of the surface.
  4. If installed, remove the system feet.

Steps

  1. Align the retention hooks on the back wheel unit with the slots on the base of the chassis, and insert the hooks into the slots.
  2. Slide the back wheel to the back of the system and secure the unit in place using a screw.
  3. Align the retention hooks on the front wheel with the slots on the base of the chassis, and insert the hooks into the slots.
  4. Slide the front wheel to the front of the system, and secure the unit in place using a screw.
    Figure 1. Installing caster wheels
    This figure shows installing caster wheels.
    1. support unit
    2. screw for support unit (2)
    3. slot on base of the tower (4)
    4. wheel assembly unit (2)
    5. screw for wheel assembly (2)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\