Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge T330 Owner's Manual

PDF

Removing the LCD module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Phillips #2 screwdriver ready.
  3. Follow the procedure listed in the Before working inside your system section.
  4. Remove the control panel assembly.
  5. Remove the control panel assembly cover.

Steps

  1. Disconnect the LCD cable. Perform the following steps to disconnect the LCD cable:
    1. Pull the retention tab that secures the LCD cable to the LCD cable connector on the control panel board.
    2. Pull the LCD cable out of the LCD cable connector.
  2. Remove the screw that secures the LCD module to the control panel.
  3. Remove the LCD module out of the control panel assembly.
    Figure 1. Removing the LCD Module
    This figure shows removing the LCD module.
    1. LCD module
    2. retention tab
    3. LCD cable connector
    4. LCD cable
    5. screw

Next steps

  1. Install the LCD module.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\