Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge T330 Owner's Manual

Replacing the power supply unit divider

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  2. If installed, remove the redundant power supply units (PSUs) or PSU blank.

Steps

  1. Remove the screw that secures the PSU divider to the chassis.
  2. Slide out the PSU divider and turn it clockwise to free the tabs on the PSU divider from the slots on the PSU cage.
  3. Slide the PSU divider out of the chassis.
  4. Align the tabs of the new PSU divider with the slots of the PSU cage.
  5. Turn the PSU divider counterclockwise and slide it in until the PSU divider is seated on the slots of the PSU cage.
  6. Tighten the screw to secure the PSU divider to the chassis.
    Figure 1. Removing and installing the PSU divider
    This figure shows removing and installing the PSU divider.
    1. PSU divider
    2. tabs (4)
    3. screw

Next steps

  1. Install the redundant PSUs or PSU blank as applicable.
  2. Reconnect the system to its electrical outlet and power on the system, including any attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\