Advanced Charge is not enabled by default. When Advanced Charge is
enabled, the feature applies to all batteries in the system, and individual
battery configuration is disabled.
Click the Advanced Charge tab in the left pane.
NOTE: Hover your cursor over the icon if you later want to see further
information on Advanced Charge.
To enable Advanced Charge, click the toggle
at the top of the page to the On position.
Click the toggle for each day of the week
to enable or disable Advanced Charge for each day.
If you enable the Advanced Charge feature, you must
configure the feature for at least one day.
To set the times of day when Advanced Charge
is active and inactive, click Settings.
NOTE: If you have not enabled Advanced Charge for a particular day, that
day will not display on the Time Settings page,
and you will not be able to set the Advanced Charge schedule for that
day. Go back to the main Advanced Charge page
and enable Advanced Charge for that particular day.
In the Time Settings screen, click a day of the week. In the main portion of the page,
you can use either the circular slider or the drop-down menus to set
the time.
NOTE: You can select times in 15-minute increments—for example, you can
enter 11:15 AM or 9:30 PM.
The circular slider represents a 24-hour period.
To use the circular slider:
Slide the Start of day thumb control to the start time of a typical workday.
Slide the End of day thumb control to the end time of a typical workday.
NOTE: The segment of time displayed in blue represents the work period,
or when the system is active.
Alternatively, you can use the drop-down menus
to set the times:
Select a time for Start of day.
Select a time for End of day.
Select the Copy the same settings
to multiple days check box. In the left pane, select the
days to which these settings apply.
Click OK to save your
settings, or click CANCEL to discard them.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\