Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

PDF

Install the PERC H755 MX adapter

Prerequisites

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE:It is recommended that you always use a static mat and static strap while working on components in the interior of the system.

Steps

  1. Turn off the sled and any attached peripherals, and remove the sled from the MX chassis.
  2. Open the sled.
  3. Connect the backplane data cable connector to the card.
    NOTE:Ensure that you connect the cable according to the connector labels on the cable. The cable does not function properly if reversed.
  4. Align the bracket notches with the tabs on the sides of the sled chassis and align the PERC card connector with the connector on the system board.
    CAUTION:To prevent damage to the card, hold the card by its edges only.
  5. Press the PERC card into the connector until it is firmly seated.
  6. Press the release lever to secure the card to the sled.
    NOTE:The pin on the release lever secures the card to the chassis of the sled.
  7. Route the data cable through the clip on the card and through the channel on the inner side of the chassis.
  8. Attach the connector to the corresponding connector on the backplane as labeled in the controller.
  9. Close the sled.
  10. Insert the sled into the MX chassis and turn on the system and any attached MX chassis peripherals.
    Figure 1. Install the PERC H755 MX adapter
    Install the PERC H755 MX adapter

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\