Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To filter routes using a route map, use these commands.

1. Create a route map and assign it a name. CONFIGURATION mode route-map map-name [permit | deny] [ sequence-number]
2. Create multiple route map filters with a match or set action. CONFIG-ROUTE-MAP mode {match | set} For information about configuring route maps, refer to Access Control Lists (ACLs) .
3. Return to CONFIGURATION mode. CONFIG-ROUTE-MAP mode exit
4. Enter ROUTER BGP mode. CONFIGURATION mode router bgp as-number
5. Filter routes based on the criteria in the configured route map. CONFIG-ROUTER-BGP mode neighbor { ip-address | peer-group-name} route-map map-name {in | out} Configure the following parameters:
   • ip-address or peer-group-name : enter the neighbor’s IP address or the peer group’s name.
   • map-name : enter the name of a configured route map.
   • in: apply the route map to inbound routes.
   • out: apply the route map to outbound routes.