Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge C4130 Owner's Manual

PDF

Installing an AC power supply unit

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. For systems that support redundant power supply units (PSUs), ensure that both the PSUs are of the same type and same maximum output power.

    NOTE: The maximum output power (shown in watts) is listed on the PSU label.

  3. If applicable, remove the PSU blank.

Steps

  1. Slide the replacement PSU into the PSU slot until the PSU is fully seated and the release latch snaps into place.

    CAUTION: When connecting the power cable, secure the cable with the strap.

  2. Connect the PSU power cable to the PSU power cable connector.

    NOTE: When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the PSU and determine its status. The power supply redundancy may not occur until the new PSU discovery is complete. Wait until the new PSU is discovered and enabled before you remove the other PSU. The PSU status indicator turns green to signify that the PSU is functioning properly.

  3. Plug the power cable into a power outlet.
    Figure 1. Installing an AC PSU
    This figure shows installing an AC PSU.
    1. release latch
    2. PSU cable connector
    3. PSU unit
    4. connector
    5. PSU handle

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"