Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.

Dell PowerEdge C4130 Owner's Manual

Removing a GPU riser cable board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Philips #2 screwdriver ready.
  3. Remove the GPU from the chassis.
  4. Disconnect the power cables connected to the GPU.

Steps

  1. Remove the screws securing the GPU riser cable board to the GPU.
  2. Pull the GPU riser cable board to disengage the connector on the GPU riser cable board from the GPU.
  3. Remove the GPU riser cable routed through the GPU riser cable clip.
    Figure 1. Removing a GPU riser cable board
    This figure shows removing of a GPU riser cable board.
    1. connector on the GPU riser cable board
    2. GPU riser cable board
    3. GPU riser cable
    4. screw (3)
    5. GPU riser cable clip
    6. GPU

Next steps

Removing the custom GPU brackets from the GPUs removed from your system.


Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"