- Notes, cautions, and warnings
- Getting started with VMware vSphere
- Getting help
VMware vSphere 7.x on Dell EMC PowerEdge Servers Getting Started Guide
Important information
- Your Dell EMC customized VMware ESXi 7.0 A00 image must be installed as a new installation or deployment.
- Dell EMC recommends you to follow the VMware recommendations published in VMware Knowledge Base article 78487 and Dell Knowledge Base article SLN320957.
- After upgrading to 7.0.x, downgrading to 6.7.x or 6.5.x is not possible.
For all the
Dell EMC PowerEdge servers with factory-installed VMware ESXi operating system:
- Dell EMC PowerEdge yx4x
and yx5x server's username is
root and password is your Service Tag of your system followed by the character '!'.
NOTE: To locate the Service Tag of your system, see Locating Service Tag of your system..
- Dell EMC PowerEdge yx3x servers do not have password for the username root.
For the
Dell EMC PowerEdge servers with a factory-installed VMware ESXi operating system on a BOSS-S1 device:
- The VMFS datastore is not enabled by default on Dell EMC PowerEdge yx4x and yx5x servers. Use the BOSS-S1 device as an operating system boot device and vSphere ESXi logging device. See VMware Knowledge Base article 2145210.
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
1～5個の星の数で評価してください。
この記事は役に立ちましたか?
コメントでは、以下の特殊文字は利用できません: <>()\