Loading, Please wait.
Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide
Enabling Serial Connection IPMI Mode Using RACADM
To configure
the IPMI mode, disable the RAC serial interface and then enable the
IPMI mode using any of the following:
- Using
config command:
racadm config -g cfgSerial -o cfgSerialConsoleEnable 0
racadm config -g cfgIpmiSerial -o cfgIpmiSerialConnectionMode < 0 or 1 >where, 0 indicates Terminal mode and 1 indicates Basic mode.
- Using
set command:
racadm set iDRAC.Serial.Enable 0
racadm set iDRAC.IPMISerial.ConnectionMode < 0 or 1 >where, 0 indicates Terminal mode and 1 indicates Basic mode.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
문서가 도움이 되었는지 여부를 선택하십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.