Avançar para o conteúdo principal
Terminar sessão

Damos-lhe as boas-vindas à Dell

Minha conta
  • Efetuar encomendas de forma rápida e fácil
  • Ver todas as encomendas e controlar o seu estado de expedição
  • Criar e aceder a uma lista dos seus produtos
  • Gerencie seus sites, produtos e contatos de nível de produto da Dell EMC usando o Company Administration.
Iniciar sessão Criar uma conta Início de sessão Premier Início de sessão no programa de parceiros
Contacte-nos

Dell PowerEdge R730 Owner's Manual

PDF

Installing the control panel

Prerequisites

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the #2 Phillips screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
    NOTE: Information tag lists system information such as Service Tag, NIC, and MAC address.
  2. To install the information tag, push the information tag into the control panel slot.
  3. Connect all the applicable cables to the control panel.
  4. Slide the control panel into the slot in the chassis and secure the module with the screw.
    Figure 1. Installing the control panel—3.5 inch hard drive system
    This figure shows installing the control panel—3.5 inch hard drive system.
    1. control panel
    2. control panel board
    3. control panel connector cable
    4. USB connector cable
    5. screw
    6. vFlash media connector cable
    Figure 2. Installing the control panel—2.5 inch hard drive system
    This figure shows installing the control panel—2.5 inch hard drive system.
    1. control panel
    2. control panel board
    3. control panel connector cable
    4. USB connector cable
    5. screw (2)
    6. vFlash media connector cable
    Figure 3. Installing the information tag
    This figure shows installing the information tag.
    1. information tag
    2. tab
    3. slot

Next steps

Follow the procedure listed in the After working inside your system section.

Classifique este conteúdo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
0/3000 characters
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Forneça as classificações (de 1 a 5 estrelas).
  Selecione se o artigo foi útil ou não.
  Os comentários não podem conter estes caracteres especiais: <>()\