Ana içeriğe atla
Oturumu Kapat

Dell'e Hoş Geldiniz

Hesabım
  • Hızla ve kolayca sipariş verin
  • Siparişleri görüntüleyin ve kargonuzun durumunu izleyin
  • Ürünlerinizin listesini oluşturun ve listeye erişin
Oturum Aç Hesap oluşturun Premier Oturum Açma İş Ortağı Programı Oturum Açma
Bize Ulaşın

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

PDF

Enabling Auto Config Using iDRAC Web Interface

Make sure that DHCPv4 and the Enable IPv4 options are enabled and Auto-discovery is disabled.

To enable Auto Config:

  1. In the iDRAC7 Web interface, go to Overview > iDRAC Settings > Network . The Network page is displayed.
  2. In the Auto Config section, select one of the following options to enable Auto Config:
    • Enable Once — Configures the component only once using the XML file referenced by the DHCP server. After this, Auto Config is disabled.
    • Enable Once After Reset — After the iDRAC7 is reset, configures the components only once using the XML file referenced by the DHCP server. After this, Auto Config is disabled.
    • Enable Always — Configures the components (using the XML file) each time the iDRAC7 receives an IP address from DHCP server.
    To disable the Auto Config feature, select Disable.
  3. Click Apply to apply the setting.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\