Ana içeriğe atla
Oturumu Kapat

Dell'e Hoş Geldiniz

Hesabım
  • Hızla ve kolayca sipariş verin
  • Siparişleri görüntüleyin ve kargonuzun durumunu izleyin
  • Ürünlerinizin listesini oluşturun ve listeye erişin
Oturum Aç Hesap oluşturun Premier Oturum Açma İş Ortağı Programı Oturum Açma
Bize Ulaşın

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

PDF

Logging Into iDRAC7 as an Active Directory User Using Smart Card

Before you log in as a Active Directory user using Smart Card, make sure to:
  • Upload a Trusted Certificate Authority (CA) certificate (CA-signed Active Directory certificate) to iDRAC7.
  • Configure the DNS server.
  • Enable Active Directory login.
  • Enable Smart Card login.

To log in to iDRAC7 as an Active Directory user using smart card:

  1. Log in to iDRAC7 using the link https://[IP address]. The iDRAC7 Login page is displayed prompting you to insert the Smart Card.
    • NOTE: If the default HTTPS port number (port 443) is changed, type: https://[IP address]:[port number] where, [IP address] is the iDRAC7 IP address and [port number] is the HTTPS port number.
  2. Insert the Smart Card and click Login. The PIN pop-up is displayed.
  3. Enter the PIN and click Submit. You are logged in to iDRAC7 with your Active Directory credentials.
    • NOTE:
    If the smart card user is present in Active Directory, an Active Directory password is not required.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\