Option
|
Description
|
AC Recovery
|
Specifies how the computer will respond when AC power
is applied after an AC power loss. You can set the AC Recovery to:
- Power Off (default)
- Power On
- Last Power State
|
Auto On Time
|
Allows you to set the time at which the computer must
turn on automatically. The options are:
- Disabled
- Every Day
- Weekdays
- Select Days
Default setting: Disabled
-
NOTE: This feature does not
work if you turn off your computer using the switch on a power strip
or surge protector or if Auto Power is set to disabled.
|
Deep Sleep Control
|
Allows you to define the controls when Deep Sleep
is enabled.
- Disabled
- Enabled in S5 only
- Enabled in S4 and S5 – This option is enabled by default.
|
USB Wake Support
|
Allows you to enable USB devices to wake the system
from Standby.
-
NOTE: This feature is only functional when the AC power adapter is connected.
If the AC power adapter is removed during Standby, the system setup
removes power from all the USB ports to conserve battery power.
Default setting: The option is disabled.
|
Wake on LAN/WLAN
|
Allows you to enable or disable the feature that powers
on the computer from the Off state when triggered by a LAN signal.
- Disabled
- LAN Only
- WLAN Only
- LAN or WLAN
- LAN with PXE Boot
Default setting: Disabled
|
Block Sleep
|
This option lets you block entering to sleep (S3 state)
in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
|
Intel Ready Mode
|
This option enables the capability of Intel Ready
Mode technology.
|