Alienware m15 R2 Service Manual

Installing the fan and heat-sink assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

CAUTION: If either the processor or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved.

About this task

The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure.

Image: Installing the fan and heat-sink assembly

Steps

Place the fan and heat-sink assembly on the system board.
In sequential order (1>2>3>4>5>6) replace the six screws (M2x3) that secure the fan and heat-sink assembly to the system board.
Connect the left and right fan cables to the system board.

Next steps

Install the system board.
Install the right I/O-board.
Install the battery.
Install the rear I/O-cover.
Install the 2230 solid-state drive. (if applicable)
Install the 2280 solid-state drive. (if applicable)
Install the base cover.
Follow the procedure in After working inside your computer.

歡迎

歡迎來到 Dell