Δημοσιεύτηκε Οκτωβρίου 06, 2025
This 3D experience gives you the step by step process of replacing the VGA Module and a Optiplex Tower 3000.
Removal
Side Cover
Identify the side cover highlighted in blue.
Loosen the thumbscrews that secure the side cover to the system.
Slide and lift the side cover away from the system.
Fan Duct
Identify the fan duct highlighted in blue.
Press the retention tabs on both sides of the fan duct to release it.
Remove the fan duct off the chassis.
VGA Module
Identify the VGA module highlighted in blue.
Remove the screws that secure the VGA module to the chassis.
Disconnect the VGA module cable from the connector on the system board.
Remove the VGA module off the chassis.
Install
Identify the VGA module location highlighted in blue.
Insert the VGA module into its slot from the inside of the chassis.
Connect the VGA module cable to the connector on the system board.
Install the screws that secure the VGA module to the chassis.
Identify the fan duct location highlighted in blue.
Place the fan duct into the slots on the chassis.
Push the fan duct toward the back panel of the chassis until it clicks into place.
Identify the side cover location highlighted in blue.
Align the tabs on the side cover with the slots and place the side cover on the system.
Tighten the thumbscrews that secure the side cover to the system.