Removal
Side Cover
Identify the side cover highlighted in blue.
Slide the release latch until your hear a click.
Slide the side cover towards the back of the computer and lift it from the system.
Front bezel
Identify the front bezel highlighted in blue.
Gently pry and release the front bezel tabs sequentially from the top.
Rotate the front bezel outward from the chassis and remove the front bezel.
Hard drive assembly
Disk drive cage
Identify the disk drive cage highlighted in blue.
Move the lock handle to unlock the disk drive cage and detach it from the chassis.
Lift the disk drive and detach it from the mounting points on the chassis.
Rotate the drive cage and place it on the chassis.
Lift the disk drive cage away from the computer.
System fan
Identify the system fan unit highlighted in blue.
Disconnect the system fan cable from the connector on the system board.
Gently pull the top rubber grommets to release the fan from the chassis.
Slide and push the bottom rubber grommets through the holes on the chassis.
Remove the system fan off the chassis.
Install
System fan
Identify the system fan location highlighted in blue.
Install the two rubber grommets to the system fan.
Place the system fan on the chassis and insert the rubber grommets through the holes on the chassis.
Slide the rubber grommets downward until they are secured to the chassis.
Insert the rubber grommets through the holes on the chassis.
Insert the rubber grommets through the holes on the system fan.
Push the system fan towards the chassis until it clicks in place.
Connect the system fan cable to the connector on the system board.
Disk drive cage
Identify the disk drive cage location highlighted in blue.
Place the disk drive cage upside down on the chassis.
Connect the data and power cable to the connectors on the optical drive.
Hold the disk drive cage upright and align with its mounting points with the slots on the chassis.
Align the screw hole on the cage with the screw hole on the chassis.
Move the lock handle to lock the disk drive cage in place.
Route the power and data cables through the routing guide on the disk drive cage.
Hard drive assembly
Front bezel
Identify the front bezel location highlighted in blue.
Align the front cover tabs with the slots on the chassis.
Rotate the front cover towards the chassis and snap it into place.
Side Cover
Identify the side cover location highlighted in blue.
Slide the side cover towards the front of the computer until you hear the release latch click.