Removal
Side Cover
Identify the side cover highlighted in blue.
Using a phillips screwdriver to turn the side panel latch to the unlocked position.
Pull the release latch to release the side cover from the system.
Push the latch and release the side cover from the system.
Lift the side cover away from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the top air shroud at the grip points and pull it upwards out of the system.
Intrusion switch
Identify the intrusion switch highlighted in blue.
Disconnect the intrusion switch cable from its connector on the system board.
Unroute the cable from the routing guides on the system.
Remove the screw that secures the intrusion switch to the system.
Remove intrusion switch along with its cable from the system.
Install
Intrusion switch
Identify the intrusion switch location highlighted in blue.
Install the intrusion switch along with its cable into the slot on the system.
Install the screw to secure the intrusion switch to the system.
Route the cable through the routing guides on the system.
Connect the intrusion switch cable to its connector on the system board.
Air Shroud
Identify the air shroud location highlighted in blue.
Align the top air shroud over the heat sink and system board.
Install and press the top air shroud down until the tabs click into place.
Side Cover
Identify the side cover location highlighted in blue.
Align the tabs with the slots and install the side cover on the system.
Use a Phillips screwdriver to turn the side-panel latch to the locked position.