Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Riser - 2A
Identify the riser highlighted in blue.
Press the blue button on the riser, and holding the touch points lift the expansion card riser from the riser connector on the system board.
System battery
Identify the system battery highlighted in blue.
Press and hold the battery socket retention latch, for the battery to pop out.
Lift the system battery out of the system.
Install
System battery
Identify the system battery location highlighted in blue.
Hold the battery with the positive side facing up at an angle and slide it under the battery socket latch.
Press the battery into the connector until it snaps into place.
Riser - 2A
Identify the riser location highlighted in blue.
Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.