Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Cooling fans
Select the cooling fan you want to replace.
Holding the orange touch points, lift the fan out of the system.
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
System Memory
Select the memory module you want to replace.
To release the memory module from the socket, press the ejectors on both ends of the memory module socket simultaneously to fully open.
Lift the memory module away from the system.
Install
System Memory
Locate the appropriate memory module socket.
Align the edge connector of the memory module with the alignment key of the memory module socket.
Press the memory module with your thumbs until the ejectors firmly clicks into place.
Air Shroud
Identify the air shroud location highlighted in blue.
Holding the edges of the air shroud, align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.
Cooling fans
Identify the cooling fan location highlighted in blue.
Align and place the fan module connector horizontally with the connector on the system board.
Press the orange touch point on the cooling fan module until firmly connected.
Air Shroud
Identify the air shroud location highlighted in blue.
Holding the edges of the air shroud, align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.