Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Riser - 2A
Identify the riser highlighted in blue.
Press the blue button on the riser, and holding the touch points lift the expansion card riser from the riser connector on the system board.
Riser - 2A Expansion Card
Position the riser so that the expansion card will be visible to remove.
Identify the expansion card highlighted in blue.
Pull and lift the expansion card retention latch lock to open.
Hold the expansion card by the edges and pull the card until the card edge connector disengages from the expansion card connector on the riser.
Install
Riser - 2A Expansion Card
Identify the expansion card location highlighted in blue.
Pull and lift up the expansion card retention latch lock to open.
Hold the card by its edges, and align the card edge connector with the expansion card connector on the riser.
Hold the card by its edges, and align the card edge connector with the expansion card connector on the riser.
Insert the card edge connector firmly into the expansion card connector until the card is fully seated.Close the expansion card retention latch.
Position the riser to install into the system.
Riser - 2A
Identify the riser location highlighted in blue.
Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Air Shroud
Identify the air shroud location highlighted in blue.
Holding the edges of the air shroud, align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.