Removal
Base Cover
Align the system with the outline to enable the AR lock.
Identify the base cover highlighted in blue.
Slide the blue tab to release the base cover from the system.
Slide the cover toward the back and lift to remove from the system.
Front Bezel
Identify the front bezel highlighted in blue.
Lift the tabs to release the bezel from the system.
Slightly lift the front of the system to release the bezel from system.
Front Panel
Identify the front panel highlighted in blue.
Lift the front panel up to open.
Intrusion Switch
Identify the intrusion switch highlighted in blue.
Disconnect the from the connector on the system board & unroute it from the fan grommet.
Push the intrusion switch over to release it and then remove it from the system.
Install
Intrusion Switch
Identify the intrusion switch location highlighted in blue
Insert the intrusion switch and slide it into the slot until it clicks into place.
Route the intrusion switch cable through the fan grommet & connect the cable to the system board.
Front Panel
Identify the front panel highlighted in blue.
Close the front panel door. Push down until it clicks into place.
Front Bezel
Identify the front bezel location highlighted in blue
Align the tab holders on the system and push the bezel until the tabs click into place.
Base Cover
Identify the base cover location highlighted in blue.
Install the cover on the system and slide it until it clicks into place.
Slide the blue tab to lock the cover to the system.