Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch until the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Turtle shell_Right
Identify the turtle shell highlighted in blue
Using the two fingers, lift the turtle shell from the DLC module.
Riser 1A
Identify the riser 1A highlighted in blue
Using a Phillips screwdriver, loosen the blue thumb screw on the riser.
Disconnect any cables that are connected to the expansion card or the riser.
Pull the plunger and slide to the unlock position (slide to the rear of the chassis).
Lift the expansion card riser from the riser connector on the system board.
Control panel Right
Identify the control panel highlighted in blue.
Remove the screws that secure the control panel cable cover to the system.
Remove the cable cover away the system.
Remove the screws that secure the control panel assembly to the system.
Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
Holding the cable, slide the right control panel out of the system.
Install
Control panel Right
Identify the control panel location highlighted in blue
Align the right control panel assembly with the slot and slide into place
Connect the right control panel cable and VGA cable to the connectors on the system board.
Route the control panel cable through the side wall of the system.
Install the screws to secure the control panel to the system.
Align and slide the right control panel cable cover in the slot on the system.
Install the screws to secure the control panel cable cover to the system.
Riser 1A
Identify the riser 1A location highlighted in blue
Holding the blue touch points, align the holes on the expansion card riser with the guides on the system board.
Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Pull the plunger and slide to the lock position (slide to the front of the chassis).
Using a Phillips screwdriver, tighten the blue thumb screw to secure the riser on the chassis.
Connect the cables to the expansion card or the riser.
Turtle shell_Right
Identify the turtle shell location highlighted in blue
Using the two finger, align and install the turtle shell on the DLC module.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a flat head or Phillips screwdriver, rotate the lock clockwise to the lock position.