Active System Manager Release 8.2 User’s Guide

VLT Enabled

VLT is a cross switch on chassis. This is a special interconnect (that is, port-channel/grouping of ports) between two peer switches.

VLT is enabled for make redundancy. If one network fail, redundant network can be used to avoid facing complete network traffic fail.

If you enable VLT, you can select VLT from port drop-down menu. Same should be selected in corresponding port, so that it can correspondent port to port.

It is not mandatory to have VLT.

NOTE: For FX2, VLT should be selected only from port 9 drop-down menu and you also must select that correspondent port for VLT.

NOTE: For M1000E chassis, we can select either VLT or Uplink from any of the ports but it has to match port-to-port. VLT is available for I/0-Agregator port but not for MXL (M100e Chassis).

Velkommen

Velkommen hos Dell

Active System Manager Release 8.2 User’s Guide

VLT Enabled

Bedøm indholdet