- Notes, cautions, and warnings
- PowerEdge FC430 system overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing sled components
- Safety instructions
- Recommended tools
- Sled
- Inside the sled
- Cooling shroud
- System memory
- PCIe mezzanine card
- Internal Dual SD Module (IDSDM) card
- SD vFlash card
- LAN on Motherboard (LOM) riser card
- Processors
- Processor blank and DIMM blank
- Solid State Drives (SSD)
- Solid State Drive (SSD) backplane
- System battery
- System board
- Trusted Platform Module
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Getting help
Willkommen
Dell Standorte
Dell Standorte
Willkommen bei Dell
Mein Konto
- Bestellungen schnell und einfach aufgeben
- Bestellungen anzeigen und den Versandstatus verfolgen
- Erstellen Sie eine Liste Ihrer Produkte, auf die Sie jederzeit zugreifen können.
- Verwalten Sie mit der Unternehmensverwaltung Ihre Dell EMC Seiten, Produkte und produktspezifischen Kontakte.
Dell PowerEdge FC430 Owner's Manual
Installing an SSD carrier
Prerequisites
CAUTION: When
a replacement hot swappable SSD is installed and the sled is powered on, the SSD automatically
begins to rebuild. Make absolutely sure that the replacement SSD is
blank or contains data that you wish to have over-written. Any data
on the replacement SSD is immediately lost after the SSD is installed.
NOTE: You must remove
an SSD to upgrade an SSD or replace a faulty SSD.
- Follow the safety guidelines listed in the Safety instructions section.
Remove the SSD blank.
Install the SSD in the SSD carrier.
NOTE: All operating
systems do not support hot swappable drive installation. See the documentation
supplied with your operating system.
Steps
- Press the release button to open the SSD carrier handle.
- Slide the SSD carrier into the drive bay and push it until the handle makes contact with the sled.
- Rotate the carrier handle to the closed position
while pushing the carrier into the slot until it locks into place.The status LED indicator displays a steady green light if the drive is installed correctly. The drive carrier LED green indicator flashes as the drive rebuilds.
Figure 1. Installing an SSD carrier 
- release button
- SSD in the carrier
- SSD carrier handle
Next steps
Follow the procedure listed in the After working inside your system section.
Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
Bitte geben Sie an, ob der Artikel hilfreich war.
Die folgenden Sonderzeichen dürfen in Kommentaren nicht verwendet werden: <>()\