Dell PowerEdge FC430 Owner's Manual

Installing the system board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

NOTE: You must remove the system board to replace a faulty system board.

Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section.
Remove the system board.
Unpack the new system board assembly.
Keep the Phillips #2 screwdriver, the 4 mm and 5 mm Hex nut drivers ready.

CAUTION: Do not lift the system board by holding a memory module, processor, or other components.

CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.

Steps

Align the system board with the standoffs on the chassis.
Secure the system board to the chassis with the screws.
Figure 1. Installing the system board
1. system board holder
2. system board

Next steps

Install the Trusted Platform Module (TPM). For information about how to install TPM, see the Installing the trusted platform modules section. For information about TPM, see the Trusted Platform Module section.
Install the following components:
- LOM riser card
- PCIe mezzanine card
- SSD cage
- SSD backplane
- SSD carriers
  NOTE: Ensure that you reinstall the SSD carriers into their original bays.
- Cooling shroud
- Memory modules
- Processor(s) and heat sink(s)
Follow the procedure listed in the After working inside your system section.
NOTE: If you are not installing the sled in the enclosure, install the I/O connector cover.
Import your new or existing iDRAC Enterprise license. See the iDRAC8 User's Guide at Dell.com/idracmanuals.
Ensure that you:
1. Use the Easy Restore feature to restore the Service Tag. For more information, see the Restoring the Service Tag using Easy Restore section.
2. If the Service Tag is not backed up in the backup flash device, enter the system Service Tag manually. For more information, see the Entering the system Service Tag section.
3. Update the BIOS and iDRAC versions.
4. Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the TPM for BitLocker users or Re-enabling the TPM for Intel TXT users section.

Willkommen

Willkommen bei Dell

Dell PowerEdge FC430 Owner's Manual

Installing the system board

Prerequisites

Steps

Next steps

Diesen Inhalt bewerten