- Notes, cautions, and warnings
- PowerEdge FC430 system overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing sled components
- Safety instructions
- Recommended tools
- Sled
- Inside the sled
- Cooling shroud
- System memory
- PCIe mezzanine card
- Internal Dual SD Module (IDSDM) card
- SD vFlash card
- LAN on Motherboard (LOM) riser card
- Processors
- Processor blank and DIMM blank
- Solid State Drives (SSD)
- Solid State Drive (SSD) backplane
- System battery
- System board
- Trusted Platform Module
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Getting help
Willkommen
Dell Standorte
Dell Standorte
Willkommen bei Dell
Mein Konto
- Bestellungen schnell und einfach aufgeben
- Bestellungen anzeigen und den Versandstatus verfolgen
- Erstellen Sie eine Liste Ihrer Produkte, auf die Sie jederzeit zugreifen können.
- Verwalten Sie mit der Unternehmensverwaltung Ihre Dell EMC Seiten, Produkte und produktspezifischen Kontakte.
Dell PowerEdge FC430 Owner's Manual
Troubleshooting Solid State Drives
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
CAUTION: This
troubleshooting procedure can destroy data stored on the SSD. Before
you proceed, back up all the files on the SSD, if possible.
Steps
- Run the appropriate tests in system diagnostics.
If the tests fail, go to step 3.
- Take the SSD offline and wait until the indicator codes on the SSD carrier signal that the SSD may be removed safely, then remove and reseat the SSD carrier in the sled.
- Restart the sled, enter the System Setup and confirm that the drive controller is enabled.
- Ensure that any required device drivers are
installed and are configured correctly.
NOTE: Installing a SSD into another bay may break the mirror if the mirror state is optimal.
- Remove the SSD and install it in the other SSD slot.
- If the problem is resolved, reinstall the SSD
in the original slot.
If the SSD functions properly in the original slot, the SSD carrier could have intermittent problems. Replace the SSD carrier.
- If the SSD is the boot drive, ensure that the SSD is configured and connected properly.
- Partition and logically format the SSD.
- If possible, restore the files to the SSD.
If the problem persists, see the Getting help section.
Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
Bitte geben Sie an, ob der Artikel hilfreich war.
Die folgenden Sonderzeichen dürfen in Kommentaren nicht verwendet werden: <>()\