Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge M1000e Chassis Management Controller Firmware Version 5.1 User’s Guide

PDF

Chassis Basic Configuration and Firmware Update

This scenario guides you to perform the following tasks:
  • Bring up the chassis with basic configurations.
  • Verify that hardware is being detected by CMC without any errors.
  • Update firmware for CMC, IOMs, and server components.
  1. CMC is pre-installed on your chassis and hence no installation is required. You can install a second CMC to run as a standby to the active CMC. For information on installing a second CMC, see the Understanding Redundant CMC Environment section.
  2. Set up the chassis using the steps provided in the Checklist To Set up Chassis .
  3. Configure CMC management IP address and the initial CMC network using the LCD panel or the Dell CMC serial console. For information, see the Configuring Initial CMC Network section.
  4. Configure the logs and alerts to produce logs and set alerts for certain events that occur on the Managed system. For information see, Configuring CMC to Send Alerts section.
  5. Configure the IP address and network settings for servers using the CMC Web interface. For information, see the Configuring Server.
  6. Configure the IP address and network settings for IOMs using the Web interface. For more information, see the Configuring Network Settings for IOM(s) section.
  7. Power on the servers.
  8. Check the hardware logs, CMC logs, and email or SNMP trap alerts for invalid hardware configurations. For more information, see the Viewing Event Logs section.
  9. To diagnose issues related to hardware, access the Diagnostic Console. For more information on using the Diagnostic Console, see the Using Diagnostic Console section.
  10. For information on errors in hardware configuration issues, see the Dell Event Message Reference Guide or the Server Administrator Messages Reference Guide located at dell.com/support/manuals.
  11. Update the firmware for CMC, IOMs, and server components. For information, see the Updating Firmware section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\