Dell PowerEdge M1000e Chassis Management Controller Firmware Version 5.1 User’s Guide

racadm <subcommand> Transport: ERROR: (RC=-1)

This message indicates that another command must be issued only after CMC completes the reset.

Using the RACADM subcommands sometimes displays one or more of the following errors:

• Local error messages — Problems such as syntax, typographical errors, and incorrect names. Example: ERROR: <message>

Use the RACADM help subcommand to display correct syntax and usage information.

CMC-related error messages — Problems where the CMC is unable to perform an action. Also might say "racadm command failed."

Type racadm gettracelog for debugging information.

While using remote RACADM, the prompt changes to a ">" and the "$" prompt is not displayed again.

If a non-matched double quotation mark (") or a non-matched single quotation (’) is used in the command, the CLI changes to the ">" prompt and queues all commands.

To return to the $ prompt, type <Ctrl>–d.

An error message "Not Found" is displayed, while using the $ logout and $ quit commands.

The logout and quit commands are not supported in the CMC RACADM interface.