Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Latitude 12 Rugged Extreme – 7214 Owner's Manual

Removing the card bracket

Steps

  1. Follow the procedures in Before Working Inside Your Computer.
  2. Remove:
    1. battery
    2. base cover
    3. docking board
    4. GPS module
    5. USH board
    6. MEMS board
    7. hard drive
    8. antenna routing bracket
    9. WLAN card
    10. WWAN card
    11. battery cable
  3. Unroute the antenna cables by removing the tapes.
    tapes
  4. To remove the card bracket:
    1. Disconnect the cable from the connector on the system board [1].
    2. Remove the screws that secure the card bracket to the computer [2].
    3. Flip the card bracket [3].
    card
  5. To remove the card bracket:
    1. Disconnect the cable from the connector [1].
    2. Lift and remove the card bracket from the computer chassis [2].
    card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\