Dell PowerEdge T630 Owner's Manual

PDF

Back panel

This image shows the back-panel features and indicators. — Figure 1. Back panel features. This image shows Back-panel features and indicators.

Table 1. Back panel indicator, button, or Connector descriptionThis table states Back-panel indicator, button, or Connector description.
Item	Indicator, Button, or Connector	Icon	Description
1	PCIe expansion card slots (3) (processor 1)		You can connect up to two PCI Express expansion cards and one PERC card.
2	Ethernet connectors		Two integrated 10/100/1000 Mbps NIC connectors.
3	System identification connector		It connects the optional system status indicator assembly through the optional cable management arm.
4	System identification button		The identification buttons on the front and back panels can be used to locate a particular system within a rack. When one of these buttons is pressed, the LCD panel on the front and the system status indicator on the back flash until one of the buttons is pressed again. Press to toggle the system ID on and off. If the system stops responding during POST, press and hold the system ID button for more than five seconds to enter the BIOS progress mode. To reset iDRAC (if not disabled in F2 iDRAC setup), press and hold for more than 15 seconds.
5	iDRAC Enterprise port		Dedicated management port. NOTE: The port is available for use only if the iDRAC Enterprise license is installed on your system.
6	Power supply (PSU1)		AC 495 W, 750 W, 1100 W, or 1600 W or DC 1100 W
7	USB port(6)		You can connect USB devices to the system. Four ports are USB 2.0-compliant and two ports are USB 3.0-compliant.
8	Video connector		You can connect a VGA display to the system.
9	Serial connector		You can connect a serial device to the system.
10	Power supply (PSU2)		AC 495 W, 750 W, 1100 W, or 1600 W or DC 1100 W
11	Full-height PCIe expansion card slots (processor 2)		Connects up to four full-height PCI Express expansion cards.