Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell PowerEdge R330 Owner's Manual

PDF

Installing the LCD control panel assembly

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Align the tabs on the control panel with the notches on the chassis.
  2. Route the LCD cable through the cable retention clip.
  3. Push the control panel toward the chassis until it snaps into place.
  4. Align and install the LCD control panel board.
  5. Secure the board in place with screws.
    Figure 1. Installing the LCD control panel—four 3.5-inch hot swappable hard drive chassis
    This figure shows installing the LCD control panel—four 3.5-inch hot swappable hard drive chassis.

    1. LCD control panel

    2. notches (6)

    3. display module cable retention clip
    4. display module cable
    5. tabs on the LCD control panel (6)
    Figure 2. Installing the LCD control panel board—four hard drive chassis
    This figure shows installing the LCD control panel board.
    1. screw (2)
    2. control panel connector cable
    3. display module cable
    4. LCD control panel board
    5. USB connector cable
    6. standoff on the chassis (2)

Next steps

Follow the procedure listed in the After working inside your system section.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \