Ga naar hoofdinhoud
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.

Dell PowerEdge R330 Owner's Manual

Installing the LED control panel assembly

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. For cabled hard drive systems, perform the following steps:
    1. Insert the LED panel into the slot in the chassis.
    2. Secure the LED panel with the screws.
  2. Insert the control panel board into the slot in the chassis and align the two screw holes on the control panel board with the corresponding holes on the chassis.
  3. Secure the control panel board with the screws.
  4. Connect all the cables to the control panel board.
    Figure 1. Installing the LED module—four cabled hard drive chassis
    This figure shows removing and installing the LED module.
    1. LED module
    2. screw (2)
    3. slot on the chassis
    Figure 2. Installing the LED control panel board—four cabled hard drive chassis
    This figure shows installing the control panel board.

Next steps

Follow the procedure listed in the After working inside your system section.


Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \