Ga naar hoofdinhoud
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.

Dell PowerEdge R330 Owner's Manual

Installing the optional internal dual SD module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

    NOTE: Temporarily label each SD card with its corresponding slot before removal.

Steps

  1. Locate the internal dual SD module (IDSDM) connector on the system board. To locate the IDSDM connector, see the System board connectors section.
  2. Align the IDSDM with the connector on the system board.
  3. Push the IDSDM until it is firmly seated on the system board.
    Figure 1. Installing the optional internal dual SD module
    The figure shows installing the optional internal dual SD module.
    1. IDSDM
    2. pull tab
    3. IDSDM connector

Next steps

  1. Install the SD cards.

    NOTE: Re-install the SD cards into the same slots based on the labels you had marked on the cards during removal.

  2. Follow the procedure listed in the After working inside your system section.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \