Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell PowerEdge R330 Owner's Manual

PDF

Installing the power interposer board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Ensure that you follow the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Align the power interposer board (PIB) with the standoffs on the chassis.
  2. Install the two screws that secure the PIB to the chassis.
  3. Connect the power distribution cables to the system board and the hard drive power connector to the hard drive backplane.
    Figure 1. Installing the power interposer board
    This image shows installing the power interposer board
    1. standoffs (2)
    2. 10 pin cable to hard drive backplane
    3. power interposer board
    4. screw (2)
    5. 28 pin cable to system board
    6. 4 pin cable to system board
    7. 8 pin cable to system board

Next steps

  1. Install the power supply units.
  2. Follow the procedure listed in After working inside your system.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \