Solved!
Go to SolutionPowerEdge SSD RAID Options
Hello,
I am looking at building a server configuration and for storage, I would like to look at the below:
- PERC H730P RAID Controller, 2GB NV Cache
- 2 x 200GB SSD (RAID 1 for Operating System)
- 4 x 400GB SSD (RAID 10)
I have seen on these forums that this or similar configurations are supported and even saw a whitepaper on Dell's website where a 4-disk SSD RAID 10 was used, but yet my assigned SE just told me that SSD drives in a RAID configuration is not "recommended" by Dell and is instead trying to sell me the SanDisk DAS Cache solution.
Just looking for some confirmation that I can utilize SSD drives in a RAID configuration AND have full Dell support. Thanks in advance to whomever can assist with this.
DELL-Josh Cr
Community Manager
•
9693 Posts
•
43676 Points
6586
0
Posted April 14th, 2015 16:00
Those OSes should work fine with the SSDs. I do not see any issues with yor configuration. The only times I have seen problems is with unsupported drives and distros that don't have a driver with HBA mode and no raid cache. With a validated OS and RAID1/10 it should run fine.
DELL-Josh Cr
Community Manager
•
9693 Posts
•
43676 Points
6587
0
Posted April 14th, 2015 15:00
Hi,
What server model are you looking at? What OS are you going to run on it? If you are using Dell validated SSDs you should not have a problem with that configuration. The controller supports TRIM and should work fine in RAID. If you are using consumer grade SSDs you may have issues.
http://i.dell.com/sites/doccontent/shared-content/data-sheets/en/Documents/PowerEdge-RAID-Controller-H730P-Spec-Sheet.pdf