We have an AX4 array with a single SP. We had a drive fault on Disk 5 (I believe it is 5). Before we were able to replace this drive, we
had an unscheduled power outage to the array. When power came back, the array started its boot. However, we now have two faulted drives, Disk 5 and Disk 0. I believe Disk 0 is a vault drive.

 

The array has been booting for over 12 hours now (green light on SP still flashing). We can ping the SP, but we cannot run any naviseccli
commands to it (Message: Error occurred because connection refused. Management Server is not running.)

 

How do we determine if it is hung in its boot, or is it rebuilding the vault drive and we just have to wait?

Any thoughts/suggestions?