Command to remove 'switchport general allowed vlan' from Interface

Question

Guys I am new to configuring this switch. I would need to know how to remove 'switchport general allowed vlan' from the interface configuration. We were testing something and I had initially configured this port as general with the allowed vlan command. Later we configured the port to trunk. The GUI shows only trunk configuration on the port, the CLI however shows trunk and the 'switchport general allowed vlan' configured. I tried the no switchport general allowed vlan command but seems like this command does not exist. How can I get rid of this command? Regards

skehoe · Accepted Answer

Enter the following command to remove the general allowed statement from the interface config. Switchport general allowed vlan remove 115,209

sandy2810 · Answer

interface Te1/0/13

switchport mode trunk

switchport general allowed vlan add 115,209

switchport trunk native vlan 115

switchport trunk allowed vlan except xxxxxxxx

exit

As you can see above, the mode says its trunk. I would however need to get rid of that general allowed vlan config. I shall try setting the port to no switchport and then enter only the trunk configuration again.

Thanks

Networking General

Was this post helpful?