Stealthrtt,

The Poweredge R710 is one of our 11th generation servers, where as the H710 is one of our 12th Generation controllers. So the problem is that the controller you have installed isn't compatible with that server. With the R710 you would need the H700 controller (512m cache = part # 1THG8, 1GB cache = part # G5V20) to use in that model server.

Now in regards to the error, it looks like the combination of hardware (memory+CPU's+ other devices) is exceeding the ability of the power supply. Try taking the server down to the minimum memory and see if that error clears, as well as if the iDrac is accessible. If so then you may want to consider upgrading from the 570W power supply up to the 870W (part # 3257W), to help alleviate the issue, or you would need to lower the amount of memory till the error isn't reported.

Let me know if this helps.

It worked using the H700 but find it odd that it doesn't work with the H710p? I thought a firmware update allowed any card to be used instead of the defaults that it shipped with officially?

I have 6 HD's that are 6TB each in size and would like to use the H710p as it states that it does support those large sized hard drives while the H700 does not seem to say anything about the support.

Is there anyway to use the H710p in the R710??

It worked using the H700 but find it odd that it doesn't work with the H710p? I thought a firmware update allowed any card to be used instead of the defaults that it shipped with officially?

Not necessarily, and ONLY if the release notes indicate such support is added. The H710 is not an upgrade option/model to the H700 - it is the model of controller supported in 12G servers, and the H700 is for 11G servers. It may work in an R710, but it was not intended to.

Hi This Thiyagu.

We are using H700 Card but still we are facing the same issue.  In our case we will shut down the server once in a week. After restarting we will receive that error PCIE Training error: Integrated Raid. Another 1 hrs it will start normally. Its happen only we shut down and boot again. Please give solution.

Thanks in Advance. 

Good day CHRIS H,

I am also experiencing the error PCIe Training Error: Integrated RAID same as Stealhrtt. But in my case the iDrac is not an issue.

Scenario:

1. The original motherboard (server motherboard for PowerEdge R710) of our HMU is working good and I was able to do the complete test for the motherboard.
2. After I replace with the new motherboard (MB1), 1 unit shows No Power/No Display symptom.
3. Another motherboard (MB2) I used boot up and I found the error - PCIe Training Error: Integrated RAID System Halted!
4. When I returned back the original motherboard, which was known working good, I am still encountering the same error -  - PCIe Training Error: Integrated RAID System Halted!

Things Done:

1. Removed all network card available except the 2 riser cards. – error still happens.
2. Checked the each RAM’s, total of 6 RAM’s, and test one by one. – error still happens.
3. Test each CPU’s, total of 2 CPU’s, and test one by one on CPU 1 socket. – error still happens.

Can you give advise what is/are the possible peripherals that got damaged with this error.

Thanks in advance.

With Best Regards,

Kevin

Hello All,

I had the same error, PCIe Training Error: Integrated RAID System Halted

Dell R710 bios 6.6.0 original controller card perc 6/i swapped out with the H700

I removed the card from the riser slow to the one above it toward the back of the case and presto!

If you're replacing your riser card, just try and unused pcie slot.

sorry guys nevermind that didn't work, it would allow me to boot, but that doesn't appear to be a slot for data