Hello,

The team is going to move this post to the Support Forums community where your question can be addressed.

Thanks,

Stephanie

This question has been moved to the Symmetrix Support Forum. This will ensure your question gets to the right audience.

Regards,

Mark

aren't you specifying the wrong device group ? Should't it be "sumitdg"

i am using the 'sumitdg' only

why did you not specify it in your symclone command ?

Helo,

If my source device are normal devices, but target devs are showing RDF1_OR_RDF2_Capable, will it cause any kind of issue?

No, its not going to cause any problem. Something is not right in your setup. Can you please post the symsg show sumitdg output?

regards,

Saurabh

symdg ?

ooops, yeah symdg show sumitdg

thanks dynamox