error when doing a stordaemon reload

Question

when I do a  'stordaemon action storevntd -cmd reload' command I get an error message in storevntd log.  Here is what the log shows. I don't know if that error is refering to the line above it (which seems to be comming from Unisphere setting, rather than daemon_options) or not.  Is this something I should be worried about?  BTW I xx'ed out most of the real IP addresses-- the log doesn't really say 1.xx.1.xx.2.xx.1.xx.          [3364              Conn-107] Dec-13 15:07:00.274 : Option setting: snmp_trap_client_registration = 1xx.1xx.2x.1xx,162,10,ACTIVE                   1xx.1xx.1xx.1xx,162,10,ACTIVE         [3364              Conn-107] Dec-13 15:07:00.274 : Option setting: snmp_host            = [3364              Conn-107] Dec-13 15:07:00.274 : [OSLProducer::evtd_oslpAction] Could not recognize the action.  [reload 0]: Symapi code 0         [3364              Conn-107] Dec-13 15:07:00.274 : Option setting: log_event_targets    = snmp file         [3364              Conn-107] Dec-13 15:07:00.274 : Option setting: log_symmetrix_events = status,events,tgt=snmp file;1114,ignore [3364              Conn-107] Dec-13 15:07:00.305 : Action cmd 'reload' received (listed above) stordaemon exited on cpw1p6200 with error code 0.

sauravrohilla · Answer

i think the best would be to open a service request with EMC support. regards, Saurabh

Symmetrix

Was this post helpful?