
UNSOLVED
FCIP Configuration
Hi All,
I need to configure SRDF over FCIP between two different DC. I have never come across FCIP so please assume I know nothing about it. However, I have read some docs and seen discussions in this forum to understand how FCIP works. Now I come up with few questions and need your help in sorting it out.
1. FCIP Setup
VMax RA - Cisco MDS 9500 - Catalyst Network switch -
WAN----- Catalyst Network switch - Cisco MDS 9513 - VMax RA
Is this correct?
2. In our Cisco MDS switch, I see FCIP is enabled (FCIP Profiles are created but not FCIP interfaces) but do not see any MPS Module GigE or IPS Module Gig ports. How to get start with?
-
Tun prof Eth-if peer-ip Status T W T Enc Comp Bandwidth rtt
E A A max/min (us)
-
1 1 11.160.4.39 DOWN N Y N N N 1000M/500M 6500
2 2 11.160.4.41 DOWN N Y N N N 1000M/500M 6500
3 3 11.160.4.43 DOWN N Y N N N 1000M/500M 6500
4 4 11.160.4.45 DOWN N Y N N N 1000M/500M 6500
Mod Ports Module-Type Model Status
--- -
-
-
-
1 24 1/2/4/8 Gbps 24-Port FC Module DS-X9224-96K9 ok
2 24 1/2/4/8 Gbps 24-Port FC Module DS-X9224-96K9 ok
3 24 1/2/4/8 Gbps 24-Port FC Module DS-X9224-96K9 ok
4 24 1/2/4/8 Gbps 24-Port FC Module DS-X9224-96K9 ok
7 0 Supervisor/Fabric-2 DS-X9530-SF2AK9 active *
8 0 Supervisor/Fabric-2 DS-X9530-SF2AK9 ha-standby
3. Have read in cisco docs about Virtual (E)ISL between GigE Ports. As it says Virtual, it doesn't need manual intervention to create it. Does it?
4. In our VMax I do see RAs are configured but doesn't have any SRDF setup. Do we need to convert this RA to RE(GigE)?
Remote Local Remote
Ident Symb Num Slot Type Attr SymmID RA Grp RA Grp Status
RF-5H 05H 117 5 RDF-BI-DIR - - 34 (21) - Online
- - 35 (22) -
- - 36 (23) -
- - 37 (24) -
- - 38 (25) -
RF-6H 06H 118 6 RDF-BI-DIR - - 34 (21) - Online
- - 35 (22) -
- - 36 (23) -
- - 37 (24) -
- - 38 (25) -
I truly appreciate your time and suggestions.
Thanks.
Responses (0)
Solutions (0)
