UNSOLVED
Problem burning with cdrw drive
Hi,
After using Roxio's ECDC for 2 yrs,I have been experiencing some new problems burning cds . During the middle of a burn using ECDC Basic 5.1_E3c, I get the message that "there is no cd in the cd recorder and ecdc will attempt to write the table of contents" or I get the message that there is not cd rw device on the computer. It will occasionally write a cd, sometimes the disc plays, others have skips or errors on the disc. I get the same inconsistent results whether I record files from my drive or from several different original music cds that have previously burned OK. So, it is not a problem with the files or disks that I am trying to burn.
A look in event viewer shows these errors and warnings that occur at time of burning
Warning Event ID 51 Source :Cd Rom
An error was detected on device \Device\CdRom0 during a paging operation
Error Event ID 7 Source: cd rom
The device, \Device\CdRom0, has a bad block
Error Event ID 9 source: atapi
The device, \Device\Ide\IdePort1, did not respond within the timeout period.
The only changes that I have made to the system have been moving some files around. Device Manager does not show any flagged problems. I defragged the drive, tried burning at lower speeds, disabled NAV and still am having trouble…
I am not sure what else I should do.
Is this a hardware or software problem?
Any suggestions are greatly appreciated. TIA
D8200 1.8
Win XP
Cd rw Lite on LTR-24102M
DVD Lite on DVD-ROM LTD 163
Message Edited by miss_k on 04-15-2004 02:21 PM
Message Edited by miss_k on 04-15-2004 02:29 PM
